Mullite setter plate for stainless components firing at 1350℃
During stainless component firing, the setter plate acts as a stable, flat carrier that isolates the product from the kiln hearth or roller, promotes uniform heat distribution, prevents direct contact with potentially reactive kiln furniture, and minimizes warpage or sticking of the sintered part. Whether used in batch furnaces, continuous mesh-belt kilns, or pusher-type sintering furnaces, our mullite setter plates provide a reliable, cost-effective solution for long-term industrial operation.
Key Features & Benefits
✔ Maximum Service Temperature 1350℃ / 1500℃ Refractoriness
The mullite crystal phase is thermodynamically stable up to ~1800℃. Our plates are rated for continuous service at 1350℃ with short-term peaks to 1450℃, maintaining dimensional stability and showing negligible creep or deformation under load—critical for preventing stainless parts from bowing during sintering.
✔ Excellent Thermal Shock Resistance
With a low coefficient of thermal expansion (CTE ≈ 4.5–5.5 × 10⁻⁶ /K, 20–1000℃) and a microcrack-toughened mullite matrix, the plates withstand rapid heating and cooling cycles (e.g., 1100℃↔air quenching) without spalling or cracking. This makes them ideal for intermittent firing schedules and periodic kiln cool-down.
✔ Chemically Inert — No Contamination to Stainless Steel
High-purity raw materials ensure very low Fe₂O₃ (<0.5–1.0%), Na₂O, and K₂O contents. The mullite surface does not react with stainless steel oxides or sintering atmospheres, eliminating yellowing, staining, or alloy pickup that can occur with lower-grade refractories.
✔ High Load-Bearing Strength at Elevated Temperature
Cold crushing strength typically ≥60–80 MPa, with retained modulus of rupture (MOR) at 1200–1300℃. The plate supports stacked or densely loaded stainless components without sagging, even in large-format thin-slab designs.
✔ Smooth, Dense Surface — Reduced Sticking
Optional fine-ground or glazed surface finish minimizes contact area and prevents sintered stainless parts from adhering to the setter, reducing scrap rates and easing post-firing part removal.
✔ Customizable Geometry
Available as plain batts, perforated plates (for improved airflow and faster heating), grooved setters (to locate components), or with recessed pockets—fully customizable in length, width, thickness, and edge profile to match your furnace car, tray, or rack system.
Recommended Applications
-
Stainless Steel Component Sintering — PM stainless bolts, fittings, filters, and structural parts fired at 1250–1350℃ in air or cracked-ammonia atmospheres.
-
Heat Treatment & Annealing Trays — Carriers for bright annealing or stress-relieving stainless assemblies.
-
Powder Metallurgy & Hardmetal Supports — Also suitable for sintering certain Fe-Cr, Fe-Ni, or ceramic-coated metal parts where contamination must be avoided.
-
Brazing Setters — Used as inert support slabs in vacuum or protective-atmosphere brazing of stainless assemblies (when combined with appropriate stop-off coatings).
-
General High-Temp Kiln Furniture — Compatible with pusher kilns, bell furnaces, box furnaces, and mesh-belt sintering lines.





